Tub & Shower Wall Surround Configurations
We can design and install your new bath tub or shower wall surround for the following configurations:
Standard Tub Wall Surround
Tub Wall with Window Cutout
Two-Piece Shower Wall Surround
The Diagram to the right shows a standard tub wall 5' high by 10' long or a 5' by 12' oversized tub wall.
These are available in Wilsonart®, Formica®, or Nevamar® plastic laminate colors. The typical back wall measurement will be approximately 59" and may extend out 30" to 42". Your exact measurements may vary. Be Cautious when measuring. Tub walls are bent to fit your exact tub wall opening. See the "order forms" for specific measurement instructions. Installation can be provided in most areas in the greater Seattle area. Contact us for more information.
The Diagram to the right shows shows a 5' high by 12' long tub wall with laminate "Legs" extending down to the floor.
The metal window has been finished off with a cultured marble sill and laminate on each side to height of tub wall. The typical back wall measurement will be approximately 59" and may extend out up to 42" on each end. .
Your exact measurements may vary. Be Cautious when measuring. Tub walls are bent to fit your exact tub wall opening. See the "order forms" for specific measurement instructions. All window cutouts are made by installer. Cultured marble sill material may be ordered in custom sizes.
The Diagram to the right shows how a "U" shape shower stall is done. We use overlapping pieces of laminate. The lower five foot panel is installed first. With the second upper panel then being installed overlapping the lower panel (3 to 4 inches) like roofing. The two-piece shower wall surround will usually run up to the ceiling. Please note that the minimum back wall measurement is 30".
Your exact measurements may vary. Be Cautious when measuring. Tub walls are bent to fit your exact tub wall opening. See Our Order Forms for specific measurement instructions.
